Bixpy Tips
SKU:
€0.00
per item
1./ Never air run your Jet, it is water cooled so should only be run in water.
2./ When finished a session if the battery is very depleted make sure to charge it again as soon as you can.
3./ After salt water use gently run a hose over the battery and motor and then place the Jet in a big bucket of water and run the motor at speed 1 for a minute or so.
4./ The Wrist remote is waterproof but it's best to just wipe it over with a cloth rather than hose it down.
5./ The motor cable stays connected to the battery - there is no need to remove it and it can stay connected when charging - it is very fiddly to keep removing this connector and not at all necessary as you may risk damaging it.
6./ Do not disconnect the motor cable from the motor - it stays connected all the time to ensure a waterproof seal
7./ When charging make sure the battery and connections are dry - it's no harm whist charging to unscrew the middle USB port cap on the battery in case any water has made it's way into the connector when rinsing and this will allow it to dry out but make sure to screw it back on after charging and before going to the water !!
8./ There are 4 caps that used to go on the end of the cable connectors and the motor and aren't needed now but keep them safe in case you need them in the future.
9./ Always make sure the kill switch is tethered to your PFD with a Karabiner in case you fall off your kayak whist on the move !!
10./ I have inscribed marks on both the battery and the motor that line up with marks on the connectors - these connectors are 100% waterproof and should never move but it's no harm to CHECK the marks are lined up before using the Jet particularly on the motor as this will show the connectors haven't become loose for some reason.
2./ When finished a session if the battery is very depleted make sure to charge it again as soon as you can.
3./ After salt water use gently run a hose over the battery and motor and then place the Jet in a big bucket of water and run the motor at speed 1 for a minute or so.
4./ The Wrist remote is waterproof but it's best to just wipe it over with a cloth rather than hose it down.
5./ The motor cable stays connected to the battery - there is no need to remove it and it can stay connected when charging - it is very fiddly to keep removing this connector and not at all necessary as you may risk damaging it.
6./ Do not disconnect the motor cable from the motor - it stays connected all the time to ensure a waterproof seal
7./ When charging make sure the battery and connections are dry - it's no harm whist charging to unscrew the middle USB port cap on the battery in case any water has made it's way into the connector when rinsing and this will allow it to dry out but make sure to screw it back on after charging and before going to the water !!
8./ There are 4 caps that used to go on the end of the cable connectors and the motor and aren't needed now but keep them safe in case you need them in the future.
9./ Always make sure the kill switch is tethered to your PFD with a Karabiner in case you fall off your kayak whist on the move !!
10./ I have inscribed marks on both the battery and the motor that line up with marks on the connectors - these connectors are 100% waterproof and should never move but it's no harm to CHECK the marks are lined up before using the Jet particularly on the motor as this will show the connectors haven't become loose for some reason.